View previous topic :: View next topic |
Author |
Message |
Etzicle Gate Opener
Joined: 02 Aug 2017 Odometer: 2 Location: Portland/LA
|
Posted: Wed Aug 02, 2017 9:22 pm Post subject: Adaptor plate specs/performance
|
|
|
Hey mike97,
Any chance you'd have specs for the adaptor plate and square bar you'd be willing to share? That save a lot of redundant effort for the community as a whole and I'd really appreciate it too! Also, how's the performance been for that adaptor plate? Allowing the engine to pivot appropriately and handling the stresses well? Is it just mounted on the left side of the block or somewhere else as well? Thanks much!
__________________________________ Om617a into Unimog 404 help! |
|
Back to top |
|
|
|
mike328 Articulating
Joined: 10 Dec 2014 Odometer: 793 Location: Suffolk!
|
Posted: Wed Aug 02, 2017 10:02 pm Post subject:
|
|
|
Not sure how much response you're going to get from a 7 year old post...
__________________________________ Snap On: Turning drawers into status symbols since 1920. |
|
Back to top |
|
|
Etzicle Gate Opener
Joined: 02 Aug 2017 Odometer: 2 Location: Portland/LA
|
Posted: Wed Aug 02, 2017 11:38 pm Post subject:
|
|
|
Any chance you have any input? I could probably figure out the mount myself.
My main questions are:
How well it works structurally having the whole engine mounted on the front driver side corner like that, further more, from where the a/c compressor used to mount.
Also, what hardware is used for that? It looks like 1/4-3/8 plate, m10-12 bolts so I'd guess if I used 1/2 inch plate with m12 grade 12.9 bolts it should be more than adequate?
__________________________________ Om617a into Unimog 404 help! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You can post calendar events in this forum
|
|
|