View previous topic :: View next topic |
Author |
Message |
Fordy 1 Gate Opener
Joined: 04 Feb 2010 Odometer: 6
|
Posted: Thu Feb 04, 2010 1:03 pm Post subject: oil presure 200 tdi
|
|
|
i resently drove my landy into deep water resulting in my timeing belt snaping. so i have took my injectors out and span it over but hardly any water come out. so i have replaced my timeing belt and push rods. started it up and it was fine then when engine gets warm oil presure ligth came on at low revs. so i replaced the oil pump and it still does the same. i have a presure tester but what should a 200 tdi run at ?
|
|
Back to top |
|
|
|
Ray_Jnr Banned!
Joined: 06 Mar 2006 Odometer: 4671 Location: The Northeast
1987 Land Rover 90 TD
|
Posted: Thu Feb 04, 2010 1:34 pm Post subject:
|
|
|
did you change the big end bearings when you did the oil pump?
__________________________________ Founder of the Difflock Ginger Goatee Club! |
|
Back to top |
|
|
Fordy 1 Gate Opener
Joined: 04 Feb 2010 Odometer: 6
|
Posted: Thu Feb 04, 2010 5:53 pm Post subject:
|
|
|
no. how do you change them tho because there is a webbing in the way when you droped the sump off. but the engine does't knock when running it sounds fine. so im out of ideas what it could be.!
|
|
Back to top |
|
|
4x4ledbury Winch Assistant
Joined: 29 Jun 2008 Odometer: 51 Location: ledbury
1997 Daihatsu Sportrak
|
Posted: Sun Feb 07, 2010 6:46 am Post subject: 3344
|
|
|
i got a oil pressure gauge in my 200 tdi 90 when on start up it reads 6 bar about 60ps.i when warm its about 35 psi -40 at normal speed and about 20-25 at idle thats when engine is warm. could be your warning light is faulty BAD EARTH OR FAULTY SENDER and you got nothing wrong or the pressure releif valve sticking in the sprocket
|
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot post calendar events in this forum
|
|
|